0 item(s) | Total: $0

$0 - $24.99
$25 - $49.99
Over $50
BROMIC COBALT SMART-HEAT™ ELECTRIC BROMIC COBALT SMART-HEAT™ ELECTRIC
$0.00
more details
Polyurethane Molded Shroud For 24" Dayton Fans
$99.00
FILTER FRAMES
$0.00
Home > Patio Commercial Heaters
 Commercial Heating Solutions

 High Intensity IR Series Infrared Heaters

Gas-fired, infrared un-vented heaters which are used in areas of high air filtration,
spot and high ceiling applications.

Features:
  •     5 year limited ceramic burner warranty
  •     CSA Design Certified
  •     Rugged non-corrosive materials in heater construction
  •     High temperature, Re-Verber-Ray-tor rods increase heater temperature and efficiency
  •     Manufactured by: Detroit Radiant Products
  •     Capacity: 100,000 BTU
  •     Propane Fueled
  •     Ignition: Millivolt Controls With Standing Pilot
  •     Includes: 35' MV Wire and MV Thermostat

 Commercial Heating


 Commercial Patio Heaters

 The best heaters in this class of industrial heaters with a wide variety of
tube packages and burner combinations from 50,000 to 175,000 BTU/h

Specs:
  • Direct spark ignition
  • 50-175 MBTU/H: BTU/H range
  • 20-60 ft. Length
  • Tube:4" dia. black coated aluminized or titanium
  • Radiant Tube:4" dia. hot-rolled steel

Electrical:
  • 120V AC, 60Hz
  • Spark ignition
  • 1.7amp startup

Available in 20 Ft. to 60 Ft. tube lengths
 
Commercial Heating Palm Springs


 Commercial industrial Heating

Models available from 40,000-175,000 BTU/HR

Heating solutions for:
  • Manufacturing plants
  • Truck terminals
  • Shops &garages
  • warehouses
  • Hangers
  • Fire stations
  • loading docks
  • Farm buildings
  • Indoor sporting arenas
  • Stables



Mr Heater Shop Heating
 
 The BigMaxx provides a warm stream of convection air blown down from above that
expands and fills your workspace.
Units require only 1" clearance from the ceiling.



HeatStar Heating

 Propane/ Natural Gas HEATSTAR Industrial Heater - FS-

 If your in the market for an easy-to-install, easy-to-operate, mountable shop heater, check
out this high intensity infrared unit. The most powerful and effective high-intensity infrared
heaters on the market. Ranging from 30k-120k btu outputs.

HEATSTAR Industrial Heaters are  primarily for HIGH ceilings in garage or warehouse applications.

Features:
  • Maintenance free
  • Efficient infrared heat
  • Complete range of outputs from 30k to 140k btu
  • Quiet, clean, odor-free operation
  • Bright Polished Aluminum Reflectors
  • No direct venting required
  • Corrosion free aluminized housing
  • Limited 1 Year Warranty
  • CSA Design Certified (Formerly A.G.A)


Specifications
BTU model
25k 40k 60k 80k 100k 120k
Clearance to Combustibles - Inches
Side
16
30
30
40
46
46
Rear
12
30
30
40
46
46
Top
14
34
40
46
48
48
Below
48
68
84
104
114
114
Recommended Mounting Height - Ft.
0-40° Deg.
8- 12
10- 16
12- 20
14- 24
16- 28
18- 30
Dimensions - Inches
L-Length
16- 1/4
22- 1/2
28- 3/4
35
41- 1/4
47- 1/2
W-Width
20- 1/2
20- 1/2
20- 1/2
20- 1/2
20- 1/2
20- 1/2
H-Height
11- 1/2
11- 1/2
11- 1/2
11- 1/2
11- 1/2
11- 1/2


NEW!!! TSR by SunPak

The TSR comes with a hand held remote control as well as a wireless wall switch.
The remote control system can be programmed to run up to 3 heaters off of just one remote control if one chooses.


Available in BLACK or STAINLESS STEEL and then upgrade to one of the 3 different New fascias.
ITEM# S34-TSR

Each natural gas or propane TSR heats an area roughly 100 square feet.
With a high setting of 34,000 BTU to a low setting of 25,000 BTU.

Each Sunpak S34-TSR heater can learn up to three different wireless device codes and multiple heaters can be
programmed to respond to a single remote control device.

While Sunpak radiant heater are designed to work in an outdoor environment, there are considerations to it's effective use:

Wind: heaters work best in a non-windy or wind protected environment.

Venting Considerations: heaters are unvented, meaning that the product of combustion vent directly from the heater into the surrounding space.

Heater Placement: The average area heated by one heater is 100 square feet or roughly a 10 ft by 10 ft area.
The optimal mounting height is 9 feet.  Sunpak heaters can be mounted horizontally, pointing straight downward, or up to a 30 degree angle.


Sunpak 2-stage Remote Heater

ALL NEW!!!!  FOR an updated look:  Add the new Sunpak Colored fascia to any Sunpak heater!

 
Download The TSR Owners Manual

Sunpak Remote Heat

See US on Yelp





Follow us on Google+ Follow our Blog